/ crusher fingerboard mount - how do I attach a beastmaker?
Any advice would be appreciated.
Just screw it on James, through the pre drilled holes. Make sure the screws go all the way into the ply and that should be fine.
Is it better to drill some right through?
If you want it to stay looking that way then just draw the outline of the beastmaker on the ply, mark some points where there will be no holds on the beastmaker then screw from the back.
Also, there are holes in the back of the beastmaker which just go into the wood and not right through. JSA, is this the kind of method that you mean? Through the mount into holes on the fingerboard like this?
And without sounding totally stupid... The holes are 4mm in diameter, do I just need a 4mm screw? I'm guessing that's how it works haha!
Screw through the BM into the mounting board. Use screws slightly larger than the holes. ie #6 or #8 screws. Sorted.
What Fraser said.
You should be crushing when you come over.
Hopefully get some good routes ticked Andy, psych levels are high!
Elsewhere on the site
In tonight's Friday Night Video, we see Alex Honnold soloing Heaven 5.12d in Yosemite Valley. The route starts 3000ft above the... Read more
Climbing as a discipline offers plentiful metaphors for tackling life's obstacles - bravery, courage, climbing to... Read more
The B.D.V. — short for Black Diamond Vertical — jacket and pants are Black Diamond’s most versatile climbing... Read more
October 21, 2014 – Textile Exchange, a global nonprofit dedicated to sustainability in the apparel and textile industry,... Read more
This streamlined, midweight thermal layer has an incredibly speedy moisture wicking ability and dries ultra fast if it gets... Read more