/ Beastmaker measurements to route out my own hangboard?
Probably somwwhere in the "back issues" of their blog - I half remember reading something about the spec.s of various incarnations before we got the 1000 and 2000 series.
On this note, is this a silly plan? I.e if i'm making my own fingerboard, why not just make, say, the four finger pockets the exact size and depth of my four fingers on each hand to the second knuckle?
Why not just screw some rails to a board, you can plane them to any angle and depth and radius you need. It's easier to finish since you're not sanding in a pocket and it's easier to re-work until it suits you.
I have since but a step in the bottom rung (so its set back) to insure better wrist postion, I asked on here for depths but in the end just made it to my own finger measurements. not as sweet as proper one but does the job.
Elsewhere on the site
Climbing as a discipline offers plentiful metaphors for tackling life's obstacles - bravery, courage, climbing to... Read more
More than 20 years after first setting eyes on the peak and noting it as a potential objective, Mick Fowler, with Paul Ramsden,... Read more
This streamlined, midweight thermal layer has an incredibly speedy moisture wicking ability and dries ultra fast if it gets... Read more
October 21, 2014 – Textile Exchange, a global nonprofit dedicated to sustainability in the apparel and textile industry,... Read more