/ Nikwax rope proof

This topic has been archived, and won't accept reply postings.
ray - on 11 May 2013
Any good?
iksander on 11 May 2013
In reply to ray: Yes - tip though, remove your tumbledryer's filter first though otherwise the residue will gum it up. When dealing with naysayers, remember the nelting point is somewhere above 200C.
ray - on 11 May 2013
In reply to iksander: dryer!! not on your nelly!!
melting point may be 200 but the dryer certainly gets hotter than the recomended temp range.
iksander on 11 May 2013
In reply to ray:

http://www.nikwax.co.uk/en-us/products/productdetail.php?productid=271

How to apply

It is essential ropes are clean before proofing
Place clean ropes in a bucket and submerge fully allowing to soak for 2 hours
Agitate every 15 minutes
Place the rope and solutions in a washing machine, set to a synthetics cycle at 40 (degrees) and allow machine to run full cycle including rinses
*Tumble dry for 60 minutes on a low or medium heat setting and allow to dry thoroughly in a well ventilated area before use or storage (recommend several days drying).*

This topic has been archived, and won't accept reply postings.