More In This Category
Jottnar Bergelmir Jacket 21 Jul 2014
The Bergelmir is Jottnar's flagship technical mountain shell, built for total protection and uncompromised performance.... [ full story ]
Regular UKC Gear Reviewer Charlie Boscoe puts the Mountain Equipment Compressor Hooded Jacket through its paces:
"The first... [ full review ]
Lightweight wind-proof jackets are an essential part of the modern British climber's gear list.
Here we give a selection of... [ full story ]
PRODUCT REVIEW: Marmot Womens Adroit Jacket 3 Jul 2014
Marmot and UKC ran a competiion a few weeks ago for the chance to win a Mens Artemis / Wm's Adroit jacket and then review it for... [ full story ]
Related UKC Forum discussions
One of the biggest jumps in performance was the introduction of the Black Diamond Drytool glove - a pretty big leap in toughness, dexterity and handling (as in you can handle gear without feeling like you're hand belongs to someone else). BD did a great job with these gloves, and they have remained a staple among winter climbers for many years.
Black Diamond Drytool glove
© UKC Gear, Mar 2009
BUT the downside of the drytool style glove is that although in moderate dry cold they provide enough protection, on colder climbs and frigid alpine routes (and belays), they become far less effective, and most climbers will have to switch to a thicker glove or mitt, or jump between the two (or three or four) as the climb progresses.
Switching between gloves has a few advantages:
But the downsides are that switching:
The reliance of good hand wear has become increased since the adoption on leashless tools, or tools with removable leashes, which require more dexterity, something offset by the fact leashless climbing increases the ability to keep fingers warmer (shaking out, faster warming etc). Never the less what's needed is a single system that's put on at the start of a route (10 metres high - or 1000), that gives great flexibility, warmth and dexterity in all conditions.
My Glove System:
The system I've developed and used over the last three years - although far from perfect - works very well - and allows easy handling of gear, good grip on tools/rock holds, and an adequate level of warmth for belays, even in pretty cold temps (-15C).
The system comprises of three components:
1. Sleeves: My climbing fleece layer has been adapted to leash-less climbing few adding an extra layer of fleece to the arms to improve warmth, with an extra long powerstrech thumbnail (ninja) style cuff also be added. This gives the arms more warmth and protects the wrist from the cold, plus adds and extra layer of warmth to the hand without reducing dexterity. The extra length in the cuff is designed to stop the cuff pulling at the crook of the thumb, which can be very painful after a while.
Outdoor Research Vert Glove
© UKC Gear, Mar 2009
2. Glove: I wear a standard Outdoor Research Vert Glove (OR's version of the Drytool), which I replace each winter, and make sure I keep the leather in good condition with wax, repairing any damage to the tips with seamgrip.
Outdoor Research Index Mitt
© UKC Gear, Mar 2009
3. Mitt: This is an Outdoor Research Index Mitt, that is warn over the top of the Drytool glove. This is just plain fleece with a rubber palm, and I made a few modifications, like sewing the thumb down so it no longer flapped up (I found this unnecessary), and I added extra seam grip to the palms as they wore out quickly. These gloves are still far from perfect (they probably won't last a full winter season, so will need repairing, and extra fleece patches sewing on).
The last time I used this system was on my ill fated crack at the Eiger and found yet again that it worked really well, keeping my fingers warm in very cold conditions. I tend to climb with the mitts done up (flap over the fingers), pulling the flap back with my teeth when I needed to use gear, or for longer stretches of harder climbing, where you be placing more gear, or doing free moves.
The pros for this system are:
One system that does everything from the bottom to the top of the route, no taking gloves on or off. Saying that I would always carry a pair of storm mitts just in case you drop a glove/mitt, or for really bad conditions. Having a single system stops any one part freezing up.
Having warm fingers means you stay more relaxed, and climb better.
Downsides of the system are if you have to remove the glove/mitt, it can take longer to put them back on, and as I said above the Index mitt does get hammered, but probably less so then a windstopper fleece mitt.
At the moment I'm working on a couple of designs for a combined glove/mitt for technical climbing (that I'm hoping to sell via http://www.andy-kirkpatrick.com), so any feed back on this, or other systems would be great.
About Andy Kirkpatrick:
Andy Kirkpatrick is the third best climber ever to come out of Hull (John Redhead and Joe Tasker pipping him at the post), and is as well known for his nerdy knowledge of gear, as his ability to climb slowly up hard routes. His knowledge of the finer points of climbing gear comes from ten years in the trade (running the rock room in Outside Hathersage), as gear editor for magazines such as Climb, Climber and High, and twenty years of climbing, often on routes where only the right gear would see you home safe (gear that very often he'd neglected to bring...or dropped!).
© Mick Ryan
Having spent two years in the wilderness writing his first book, Psychovertical (published by Hutchinson, Andy is returning to climbing gear writing here at UKClimbing.com with Doctor Gear, an irregular surgery for all gear and strange technique questions. If you would like to book an appointment, then please submit any questions to the associated Premier Post (please note Andy will not treat your questions confidentially in any way!).
You can buy a signed copy of his booky wooky and read Andy's words on gear, climbing and life at: www.andy-kirkpatrick.com
Andy Kirkpatrick is sponsored by / works for Berghaus and Lyon Equipment.
UKC Articles and Gear Reviews by Andy Kirkpatrick: