/ crusher fingerboard mount - how do I attach a beastmaker?
Any advice would be appreciated.
Just screw it on James, through the pre drilled holes. Make sure the screws go all the way into the ply and that should be fine.
Is it better to drill some right through?
If you want it to stay looking that way then just draw the outline of the beastmaker on the ply, mark some points where there will be no holds on the beastmaker then screw from the back.
Also, there are holes in the back of the beastmaker which just go into the wood and not right through. JSA, is this the kind of method that you mean? Through the mount into holes on the fingerboard like this?
And without sounding totally stupid... The holes are 4mm in diameter, do I just need a 4mm screw? I'm guessing that's how it works haha!
Screw through the BM into the mounting board. Use screws slightly larger than the holes. ie #6 or #8 screws. Sorted.
What Fraser said.
You should be crushing when you come over.
Hopefully get some good routes ticked Andy, psych levels are high!
Elsewhere on the site
Manchester Climbing Centre are showing Brit Rock on Thursday the 27th of November at 7pm. Homegrown adventure comes... Read more
Every so often you meet someone in climbing that makes you take a step back. Someone with a fire in their eye, passion in... Read more
Hold on there. This is not your everyday, average hooded down jacket. Insulated with PrimaLoft® GOLD 750, a... Read more
This week's Friday Night Video is an interview with Mina-Leslie Wujastyk filmed by Nick Brown. On 14th October 2014, Mina... Read more
Nuts, wires, stoppers, chocks, wedges, whatever you want to call them, have been around for a long time. Initially made from... Read more