In reply to Reach>Talent:
> (In reply to Timmd)
> I have the sneaking suspicion your flask has gone to flask heaven. If you manage to pull a dent in a stainless flask using araldite I'll eat this report I'm writing (40+ pages with lots of graphs), you'll never get a good enough adhesion on a small point Heating it won't work either.
>
> If you were really desperate and really bored you could always try pulling it with a welding rod? Weld a bit of welding rod onto it, pull on that and then grind it off. I don't fancy your chances though.
>
> I admire your make do and mend attitude though!
I fear you might be right, it's kind of a flat dent though, so I might have a go using some flat aluminium strip which is up at my parents. Took the base off to see if I could press it out from within, but it looks like it's made in one piece, it's not get-at-able.
It's the resources which have gone into making it which are in the back of my mind, it almost seems a shame to throw it out without having a go at undenting it.
I've already fixed the handle with an offcut of bike brake cable and a couple of nuts and bolts I inherited.
(
)