UKC

My kitchen sink & draining board unit has a blank to cover the unused tap-hole. The blank has come loose and I can't gain access to tighten it.

Is there any reason why I shouldn't glue it in place?
If not, would Araldite be a suitable glue?

Many thanks for any helpful replies.

steel sink? personally i would look for something flexible - silicone maybe 

Many thanks for your advice. Time to get stuck in!

(I'll get me coat...)

Bonding it in position is fine unless you might want to get it out again.

If you don't then araldite would be fine. I use Araldite rather than silicone simply because it'll cure in an you or so opposed to one to three days for silicone.

You can get a blank that is held in by spring tabs, when siliconed in place it will stay in place as the silicone sets and is removable if required

I've glued our's araldite, we're never going to fit a tap where the hole is so why not?

Thanks, everyone. Job done.